BASIC USE INSTRUCTIONS — TEXT VERSION

1. Prepare water in a container.

2. Add CW7882-SEV at the following mixing ratio:

For the dipping method: Water 1,000 : HairCoat 3–5 (0.3-0.5%)

For example:
1,000 g (or mL) of water + 3–5 g (or mL) of CW7882-SEV

For the spraying method: Water 1,000 : HairCoat approximately 10 (1%)

A somewhat higher concentration is recommended for spraying to compensate for overspray and airborne loss during application.

3. Applying
For the dipping method: Dip the human hair or hairpiece into the solution for approximately 10 seconds.

For the spraying method: Spray the solution evenly onto the hair until the hair is sufficiently and uniformly wetted.

For the spraying method, spray the JK-HairCoat solution with one hand while quickly touching, gently rubbing, separating, and moving the hair with the other hand, wearing a clean disposable plastic glove.

Keep moving your fingers through the hair while spraying so that the JK-HairCoat solution spreads evenly over all the hair.

4. Remove excess moisture if necessary, and dry the hair properly by air drying, using a hair dryer, or oven drying, depending on the condition and type of hair.

* Air drying: Keep the hair away from dust and other contaminants while drying.

* Hair dryer: Do not use excessively hot air.

* Oven drying: For normal, healthy human hair, a temperature of approximately 75–80°C may be used. For damaged, weakened, heavily bleached, or otherwise heat-sensitive human hair, use a lower temperature, approximately 40°C or below.

For synthetic fiber that is not specifically made to withstand high temperatures, also use a low drying temperature, approximately 40°C or below.

That is the basic procedure.